Base Corner Blind Cabinet Assembly

Tools and Materials Needed

Dead Blow Hammer, Impact Driver, Camar Leveling Legs, Camar 15mm Leg Sockets, Blum Cliptop Mounting Plates, Blum Cliptop 95-degree Hinges with Blumotion

Screws Needed

8 x 1 ¾ (4×45 / 26mm) Screw with Countersunk Head (Used for Cabinet Box Assembly)

Box Part 1

  1. Lay the end panel on a level surface
  2. TIP: check that all female Lamello P-14 Tenso fasteners are level and centered within their slots
  3. Insert the male Lamello P-14 Tenso fasteners into the slots
  4. Snap into place
  5. Check for flush on the front face
  6. Snap the top rails into place
  7. Make the top rail flush with the front face

Box Part 2

  1. Place the back panel into the groove
  2. Keep the rabbeted edge facing out
  3. Set the other side panel on top
  4. TIP: check that all female Lamello P-14 Tenso fasteners are level and centered within their slots
  5. Line up all Lamello P-14 Tenso fasteners
  6. Snap into place
  7. Check for flush on the front face (using a Dead Blow Hammer for adjustments, if needed)
  8. Nudge the other top rail tight against the cabinet back

Screwing the box together

  1. Fasten the cabinet together with #8 x1¾ 4×45/26mm Screw with Countersunk Head
  2. Follow the pilot holes around the top and bottom of the cabinet sides AND cabinet back

Legs

  1. Flip the cabinet on its head
  2. Place leg sockets into the deep 15mm pilot holes
  3. Socket tabs must be pointing toward the sides of the cabinet
  4. Screw sockets into place with #6 x ½ Flat Head Wood Screws
  5. NOTE: The 1 shallow hole is for orientation, indicating the front of the bottom panel
  6. With a dead blow hammer, pound the leg levelers into each socket
  7. Twist the bottoms to adjust leg height as needed

Blind Panel

  1. Flip the cabinet onto its back with the face side up
  2. Grab the blind panel and set gently in place
  3. Locate the hinge mounting plate holes
  4. The mounting plate arrows should be pointing toward the edge of the blind panel
  5. Screw the Blum Cliptop Mounting Plates in place
  6. Flip the panel over, with the finished side facing out
  7. The Mounting plates should be positioned on the interior edge where the door will be mounted
  8. Make the blind panel flush with the top rail, bottom, and side panel
  9. Follow the pilot holes around the perimeter of the panel
  10. Secure the blind panel with #8 x1¾ 4×45/26mm Screw with Countersunk Head

Door

  1. Grab the Blum Cliptop 95-degree Hinges with Blumotion
  2. Press and snap into place on the door
  3. Line up the hinges with the mounting plates
  4. Snap and lock the hinges into place