Double Bin Trash Pull-Out cabinet Installation (ENVI BMT Planero)

tools and preparation

  1. Confirm Fit and Tools
    • This pull-out holds two 50-quart bins and fits 15″ or 18″ cabinets.
    • Tools – Drill / Impact Driver, Phillips Bit, 5/16″ Bit, 3/32″ Bit, Tape Measure, Pencil, Speed Square, and Blue Painter’s Tape.
  2. Unbox and Organize
    • Open the box and remove all parts.
    • Keep the large instruction paper—this will be used as a template.

SCREWS NEEDED

  • All screws are included within the Trash Pull-Out packaging. There are three different screw types included in the larger “Wurth” box, and the toe-kick mechanism box including its respective screws as well.

Assemble the Pull-Out Frame

  1. Attach Plastic Connectors
    • Install the left and right plastic pieces to the bottom panel (marked L and R).
  2. Install Side Panels
    • Slide both side panels into the bottom using the plastic connectors.
  3. Secure the Frame
    • Tighten machine screws to lock the sides to the base.
  4. Add the Top Panel
    • Line up the hooks and holes, slide the top piece into place.

Install Slides in the Cabinet

  1. Use the Paper Template
    • Place the template inside the cabinet to mark glide locations.
  2. Adjust for Frameless Cabinets
    • Set the template back ¾ inch from the front before drilling.
  3. Drill Pilot Holes
    • Drill the marked holes (15″ or 18″ depending on your cabinet size).
  4. Mount the Slides
    • Install slides using the slotted holes first.
    • Test fit the pull-out base, then install remaining screws.

Install the Toe-Kick Mechanism

  1. Drill Toe-Kick Holes
    • Center the provided plastic guide and drill two holes with a 5/16″ bit.
  2. Mount the Mechanism
    • Insert the pegs through the cabinet bottom and secure with screws.
  3. Finish With the Cap
    • Snap the plastic cover over the toe-kick hardware.

Attach and Adjust the Door

  1. Prepare the Door
    • Flip the template to side B.
    • Measure ¾” up from the bottom of the door and align the template there.
  2. Drill Door Bracket Holes
    • Drill the marked holes and attach the left and right door brackets.
  3. Connect Door to Pull-Out
    • Insert the brackets into the frame slots and loosely hand-tighten screws.
  4. Adjust Alignment
    • Use adjustment screws to fine-tune:
      • In/out
      • Up/down
      • Left/right
  5. Lock in Final Position
    • Tighten all screws once margins are even.
    • Snap on the plastic cover caps.

Finish Up

  1. Insert Trash Bins
    • Place both trash cans into the pull-out frame.
  2. Test Operation
    • Press the toe-kick to confirm smooth opening and closing.
  3. Installation Complete
    • The trash pull-out is now fully installed and ready to use.

Key Tips

  • Always use blue tape to protect cabinet finishes.
  • The ¾” setback is essential for frameless cabinets.
  • Double-check left/right part orientation before installing.