Upper Corner Blind Cabinet Assembly

Tools and Materials Needed

Dead Blow Hammer, Impact Driver, Blum Cliptop Mounting Plates, Blum Cliptop 110 Degree Hinges with Blumotion, Blum Cliptop 270 Degree Hinges with Blumotion

Screws Needed

8 x 1 ¾ (4×45 / 26mm) Screw with Countersunk Head (Used for Cabinet Box Assembly)

Box Part 1

  1. Lay the end panel on a level surface
  2. TIP: check that all female Lamello P-14 Tenso fasteners are level and centered within their slots
  3. Insert the male Lamello P-14 Tenso fasteners into the slots
  4. Snap into place
  5. Check for flush on the front face
  6. Align the male Lamello P-14 Tenso fasteners into the slots
  7. Snap into place
  8. Check for flush on the front face

Box Part 2

  1. Place the back panel into the groove
  2. Keep the rabbeted edge facing out
  3. Set the other side panel on top
  4. TIP: check that all female Lamello P-14 Tenso fasteners are level and centered within their slots
  5. Line up all Lamello P-14 Tenso fasteners
  6. Snap into place
  7. Check for flush on the front face

Screwing the box together

  1. Fasten the cabinet together with #8 x1¾ (4×45/26mm) Screw with Countersunk Head
  2. Follow the pilot holes around each side panel

Blind Panel

  1. Flip the cabinet onto its back with the face side up
  2. Grab the blind panel and set gently in place
  3. Locate the hinge mounting plate holes
  4. The mounting plate arrows should be pointing towards the edge of the blind panel
  5. Screw the Blum Cliptop Mounting Plates into place
  6. Flip the panel over, with the finished side facing out
  7. The Mounting plates should be positioned on the interior edge where the door will be mounted
  8. Make the blind panel flush with the top, bottom and side panel
  9. Follow the pilot holes around the perimeter of the panel
  10. Secure the blind panel with #8 x1¾ 4×45/26mm Screw with Countersunk Head

Hinge Plates

  1. Locate the hinge mounting plate holes on the side panel
  2. The mounting plate arrows should be pointing toward the front face of the cabinet
  3. Screw the Blum Cliptop Mounting Plates into place

Door

  1. Grab the Blum Cliptop 110° Hinges with Blumotion
  2. Press and snap into place on the door
  3. Grab the Blum Cliptop 270° Hinges with Blumotion
  4. Press and snap into place on the door
  5. Line up the hinges with the mounting plates
  6. Snap and lock the hinges into place